Dac boardet lader vente på sig. Har betalt det og ventet og ventet
Forklaringen har jeg så for nylig fået. UK distributøren har svigtet og Divine Audio skal have produkterne direkte fra Unison research.
Claus,
We aim to reply to all emails within 48 hours, not including weekends. I replied to this email from the store this afternoon.
As mentioned earlier and in previous emails - the UK distributor is failing and we are sneaking items directly out of the factory. This has taken a lot longer than thought, but we are getting there.
Later on in the year, we hope a normal service will resume with the supply of Unison Research products.
In the meantime, if I can be of further assistance please get back to me - and allow a reasonable time for me to reply!
Kind Regards
Tim Chorlton
Divine Audio Ltd
Har dog instruktionen her for hvordan boardet monteres videregivet af Divine Audio
Måske til gavn for andre Unison Research CDE ejere der går med tanker om ar upgradere med dette kit.
Unison Research CDE DAC upgrade instructions.
In order to install the optional Digital To Analogue conversion board DAC_OP2 you’ll need to follow a few simple steps:
- switch off and disconnect the Unico CDE player from the mains;
- remove the top cover by unscrewing the 12 screws fixing it;
- locate the DAC board on the front left side of the unit;
- locate the couple of 16 pins strip connectors J9 and J10 on the rear side of the
DAC board;
- remove the 6 black plastic jumpers from the connectors (keep them, you may
need them);
- plug the DAC_OP2 board onto the J9 and J10 connectors.
Make sure that:
- when looking the unit from the front side, the DAC_OP2 board is rotated so
that you can read the “DAC_OP2” printing on the left bottom side (see
following pictures);
- all of the pins of J9 and J10 connectors match the female connector on the optional board.

__________________
"Det er musikken det drejer sig om"